Faulty BMW VANOS solenoids are a common source of check engine lights and limp mode (Engine Malfunction - Half Engine Light). The two most common codes you will see when this solenoid is operating erratically is 2A87 and 2A82. Usually, restarting your BMW can make the code or problem go away temporarily but it is likely for the problems to come back again.

//If the video was helpful, remember to give it a "thumbs up" and consider subscribing.//

Disclaimer: Due to factors beyond the control of Charles Gonzales, I cannot guarantee against improper use or unauthorized modifications of this information. Charles Gonzales assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Charles Gonzales recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of Charles Gonzales, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Charles Gonzales.

BMW 335i N54 throws limp mode. E92 anti lag half engine light. N54 engine misfires DIY. Bimmergeeks KDCAN cable with MHD Tuning and codes. OTF Stage 1 stage 1+ stage 2 stage 2+ burble backfires. VSRF FBO Full bolt ons. Engine Malfunction.

#n54 #bmw #guide