In part twelve of this series, I install the chain plates, show how to use "tick sticks" for flagging off and making the fore and aft bulkheads, and clean up the interior of the boat. I radius all the edges in the cockpit and bevel the chine log to shed water. I also sand to a 220 grit finish in prep to paint. Finally I spray on two coats of primer and start rolling on a third coat.

Plans & Information: https://snipeusa.com/ https://www.snipe.org/

Supplies:
Epoxy - https://amzn.to/2FN7fHp
Marine Plywood - https://www.boulterplywood.com/
Sander: https://amzn.to/3bmUG2D
Sanding Disks: https://amzn.to/2wkDxYT
Vacuum: https://amzn.to/2Uw8ktt
Rollers: https://amzn.to/3dinA5Y
Scrapers: https://amzn.to/3acOx9i
Epoxy Mixer: https://amzn.to/3dohJvN
Epoxy Cups: https://amzn.to/394S0p2
Fiberglass Tape: https://amzn.to/2WB2SrW

Camera Equipment:
Canon SL2 - https://amzn.to/2GPW1ms
Tripod - https://amzn.to/2XWVhSd
GoPro Hero7 White: https://amzn.to/2ITsqtj